Architectural/Commercial
TIMELY PREFINISHED STEEL FRAMES
The Timely Prefinished Steel Frame is installed AFTER the
drywall is applied and painted. The concept of installing
a prefinished frame and a prefinished door all at the
same time not only provides a level of structural integrity,
but also saves precious time and money at jobs end
because there is no painting/finishing to do. Applying the
prefinished TA-8 metal casing is a “snap” with Timely’s
unique casing clips and the casing corner connector holds
mitred corners of casing in a tight fixed position.
Structural integrity (frame
becomes part of the wall)
Casing Corner Connector Mitred corners are held in tight fixed position by special corner backing pieces.
Aligning Tab
Full width aligning tabs
attached to header section to
guide and secure frame sides
to header in correct alignment.
Fastener Holes
Pre-punched hole for easy
insertion of fasteners.
Casing Clip
Improved individually attached
heat treated clips assure snug
casing fit.
Alignment Slot
Oval punch-outs allow visual
check of frame spacing over
the rough opening during
installation.
Reversible
Hardware Locations
No handing required
in 6'-8" heights.
Hinge Replacement Plate
14 gauge hinge reinforcing
plates are factory attached to
accommodate hinges required.
Timely Steel Frames are for interior use only.
Flush Bracket to
edge of Header
Closer Arm
Shoe
Header
Casing
Paper
Backing
Very High Bond
Double Face
Tape
Two wood or steel
stud screws
TA-12
Sleeve
TA-10 Reinforcement
Brackets
B254
